FUNCTIONS ENABLED BY RADIO CONTROL:

Tag Rabbit / Snail is function for speed, rabbit enables 100% output speed on every lever, snail is 50%.

Tag DSC (Dynamic speed control) is a function that allows the operator to temporarily increase the output power (speed) in the "snail" mode. With this function you can increase or decrease the speed and these settings will remain until the receiver is turned off. When you turn the receiver back on, the speed reverts back to the default values assigned to the "snail".

Tag IN-SLOW is a digital input intended for lifting platforms (those with operators). If this pin is activated (usually a mechanical switch that automatically activates when the lift is mounted on the crane), all moves go directly to 10% speed and only one move is allowed at a time.

Tag RPM +/- usually when increasing the engine speed, you increase the oil pressure, making the crane speed faster or slower.

Tag MOTOR on/off function intended for the truck engine (if it supports it).

IMPORTANT: For the correct configuration and operation of the radio proportional controller, please provide us with the information for the following three elements from the following photo below: 

1. Length for the centre between spools, defined as the distance from the spool centre to the next spool centre - given in mm.

2. Spool stroke from the zero (0) position in mm in one direction, defined distance to move the spindle in one direction from the starting position (0) when the lever is moved in one direction - given in mm,

3. Voltage 12/24V, defined source of supply voltage - 12V or 24V.

Video: